Setting password protection, Assigning an ip address – Cabletron Systems SmartSTACK ELS100 User Manual
Page 66

52 Configuring & Monitoring The Switch
ELS100-24TX
Setting Password Protection
The ELS100-24TX switch is factory-configured with access rights to the 
console menus set to READ/WRITE. This setting allows anyone to use 
the console menus to modify any operational parameter. To protect the 
configuration of the switch from unauthorized modification, you should 
enable password protection to the console menus.
To enter a password, do the following:
1.
Select Password from the System Configuration Menu and 
press [Enter].
2.
Enter a password containing six to eight alphanumeric characters.
The password is not case sensitive. For verification, you are asked to 
enter your password again. If both entries agree, the new password is 
stored.
By factory default, there is no password configured. This means that at 
the 
login:
prompt, all you have to do is press [Enter] to gain READ/
WRITE access to the console menus. When you configure the password 
parameter, the factory default setting is deactivated and the new 
password governs access to the console menus.
After you enter a password and logout using the Logout command from 
the Main Menu, all access rights change to READ-ONLY. The current 
level of access control is indicated at the top of the management screen. 
If you forget your password, contact your NetVantage System Support 
Representative.
Assigning an IP Address
To assign an IP address to the switch, do the following:
1.
Select System Configuration Menu from the Main menu.
2.
Select IP address from the menu and enter the IP address. 
Press [Enter].
The IP address is now programmed. The subnet mask is automatically set 
to correspond to the class of the address entered. If a different mask is 
used on the network, select Subnet Mask from the menu and enter the 
appropriate mask.
You are automatically logged out from the console menus 
based on the Screen Timeout setting in the System Config-
uration Menu. A setting of “0” permits the console menus 
to remain available indefinitely.
