Kistler-Morse KM Weigh II - Manual (Page 8)

Methods of Operation
The Weigh II has two methods of operation:
• Vessel Monitoring — vessel parameters
(weight, level, or some other indication of
vessel contents) are displayed on the LCD.
Vessel monitoring can be set to monitor
and display information on each of the
vessels in the system (Auto Mode)
sequentially or on only one vessel (Manual
Mode). When in the Manual Mode, use of
the keyboard allows the user to manually
scroll to other vessels.
• Menu Operation — system parameters for
display, input/output, calibration,
and troubleshooting can be viewed
and modified.
Note
Throughout this manual, the term
“weight” is used to refer to an indica-
tion of the quantity of material in the
vessel. However, the Weigh II can be
set up to display weight, level, volume,
percentage, voltage, or current associ-
ated with the material quantity (see
Chapter 4, Display). If you are using
some measure other than weight, all
inputs must be consistent with your
chosen measure.
Manual Conventions
Three kinds of special explanations appear
throughout the manual — WARNING, CAU-
TION, and Note. The format and significance
of each is defined below:
WARNING
Possible danger to people. Injury
may result if this information is
ignored.
CAUTION
Possible risk to the product. The
Weigh II or other equipment may be
damaged if this information is ignored.
Note
Contains additional information about a
step or feature critical to the installa-
tion or operation of the Weigh II.
Chapter 1. Weigh II Introduction
1-2