Kistler-Morse KM Weigh II - Manual (Page 60)

7-10
Chapter 7. Service
the first time you attempt to change a
system parameter within one Manual Mode
session (i.e., you will only need to enter the
code once per Manual Mode session,
regardless of the number of parameters you
change and channels you access).
K M
The Weigh II has two factory code numbers.
Certain troubleshooting functions require one
of these code numbers be entered before
access to the function is permitted. The
Service Code was described earlier in this
chapter, and is entered when prompted by the
display. The Mfg Code is entered when in the
Access Menu, as described below:
KM Mfg Code
The KM Mfg Code is required to access
hidden menus, which are typically only used
by Kistler-Morse personnel for troubleshoot-
ing and testing the equipment. The KM Mfg
Code also allows the user to change values in
the Service Menu. The KM Mfg Code number
is:
9111
This number is entered when in the KM
function under the Access Menu. Once the
number is entered, you have access to all
functions and hidden menus that require the
code, while you remain within the Manual
Mode (i.e., you will only need to enter the
code once per Manual Mode session,
regardless of the number of functions and
channels you access).
The KM Mfg Code has precedence over the
KM Service Code. If you enter the KM Mfg
Code in the KM function under the Access
Menu, the Weigh II will not require you to
enter the KM Service Code when you change
values in the Service Menu.