Kistler-Morse KM Weigh II - Manual (Page 23)

Chapter 4. Display
4-3
5. Press the F2 Key to access the Cntby
Menu. The display shows:
An asterisk indicates the current
selection.
6. If the displayed menu does not have the
desired countby, press the Menu Key to
display the second page of the menu. The
display shows:
Continue to press the Menu Key until you
see the desired countby (there are four
pages to the Cntby Menu).
7. Press the F1, F2, or F3 Key to select the
desired countby. The display acknowl-
edges your selection and then returns to:
8. Press the Esc Key to scroll up the menu
tree or press the Auto/Man Key to return
the display to vessel monitoring.
Units
This menu allows you to select the unit of
measure for the vessel monitoring display. In
the Common submenu, you can select from
lbs (pounds), Kgs (kilograms), tns (tons), gal
(gallons), Ltr (liters), Brl (barrels), % (per-
cent), ft (feet), in (inches), V (volts), mV
(millivolts), and mA (milliamps). In the
Custom submenu, you can type in a custom
three-character unit of measure. The default
unit is XXX.
Follow this procedure to select a Common
unit of measure.
1. If the Weigh II is in Auto Mode (Auto LED
illuminated), press the Auto/Man Key to
put the system in Manual Mode. The Auto
LED turns off.
2. Use the Up Arrow or Down Arrow Keys to
scroll to the desired channel.
3. Press the Menu Key to display the Main
Menu. The display shows:
4. Press the F1 Key to access the Display
Menu. The display shows:
5. Press the F3 Key to access the Units
Menu. The display shows:
6. Press the F1 Key to access the common
Menu. The display shows:
7. If the displayed menu does not have the
desired unit, press the Menu Key to
display the second page of the menu. The
display shows:
Continue to press the Menu Key until you
see the desired unit (there are four pages
to the Common Menu).
8. Press the F1, F2, or F3 Key to select the
desired unit. The display acknowledges
your selection and then returns to:
9. Press the Esc Key to scroll up the menu
tree or press the Auto/Man Key to return
the display to vessel monitoring.
ID (Identification)
This menu allows you to type in a
16-character alphanumeric title to identify
each channel on the display in a meaningful
manner. The Weigh II arrives from Kistler-
Morse with a factory-set ID number assigned
for each channel in the system.
After you have input a customer-defined ID,
you can still view the original factory-set ID
when vessel monitoring in the Manual Mode
by pressing the Esc Key.
Follow this procedure to input a customer-
defined ID.
DISPLAY MENU
Avg Cntby Units
F1 F2 F3
WII MAIN MENU
Disp I/O Cal
F1 F2 F3
UNITS OF MEASURE
common custom
F1 F2 F3
PRE-DEFINED UNIT
lbs Kgs tns
F1 F2 F3
PRE-DEFINED UNIT
gal Ltr Brl
F1 F2 F3
DISPLAY MENU
Avg Cntby Units
F1 F2 F3
CHOOSE COUNTBY
*1 2 5
F1 F2 F3
CHOOSE COUNTBY
10 20 50
F1 F2 F3
DISPLAY MENU
Avg Cntby Units
F1 F2 F3