Kistler-Morse KM Weigh II - Manual (Page 69)

Appendix B. Summary of Commands Used When Vessel Mounting -- Hot Keys
B-1
Appendix B. Summary of
Commands Used When
Vessel Monitoring — Hot Keys
This Appendix contains a summary of the
keyboard functions (hot keys) you can use
when vessel monitoring.
• Switch from Auto Mode to Manual
Mode or vice versa —
Press the Auto/Man Key (Auto LED
illuminates when the Weigh II is in
Auto Mode).
• Scroll through the Channels when in
Manual Mode —
Press the Up Arrow or Down Arrow Key.
• Tare the Vessel —
Press the Shift Key (Shift LED illuminates
when the Shift Key is on). Then, press the
Tare/Net/Gross Key.
• Switch from Gross Weight to Net
Weight or vice versa —
Make sure the Shift Key is off (Shift LED is
not illuminated). Then, press the
Tare/Net/Gross Key.
• Switch from Numerical display to Bar
Graph display or vice versa for a
particular channel —
If you set up the bargraph (see Chapter 4,
Display), press the Enter Key while in the
Manual Mode to toggle between numerical
display and bar graph display.
• Enable or Disable the Hide function —
Press the Shift Key (Shift LED illumi-
nates). Then, press the “9” Key.
• View Factory-Set ID —
If you input a customer-defined ID but want
to see the factory-set ID for a channel,
press the Esc Key while in the Manual
Mode.
• View Serial Address for a channel —
Press the Esc Key while in the
Manual Mode.
• Display Current Weigh II Software
Revision letter and Date of Release —
Press the “.” Key briefly while in the
Manual Mode.