Kistler-Morse KM Weigh II - Manual (Page 31)

Chapter 5. Inputs and Outputs
5-3
Delete
This menu allows previously added setpoints
to be removed from the current vessel. The
top line of the display shows an assigned
setpoint number. The bottom line shows the
slot number of the setpoint PCB and the
channel number for the setpoint on the
setpoint PCB.
To delete a setpoint, cycle through the
setpoints by pressing any key other than
Esc, Auto/Man, or Enter until the setpoint
you want to delete is displayed. Then, press
the Enter Key. To prevent accidental deletion,
the display requests verification that you want
to delete the setpoint channel. If the response
is Yes then I/O Channel Deleted displays to
confirm the deletion. This setpoint channel is
now available for use again.
Add
This menu is used to add setpoints (up to
eight) for the current vessel. Note that the
setpoint must be added before the Set
parameters (Val, Dead, etc.) can be input.
The top line of the display shows the first
available setpoint number. The bottom line
shows the slot number of the setpoint PCB
and the channel number for the setpoint on
the setpoint PCB. Pressing any key other
than Esc, Auto/Man, or Enter cycles through
all other unassigned setpoint channels.
Pressing the Enter Key adds the setpoint.
Setting Up the Setpoints
Follow this procedure to add and set up
setpoints.
1. If the Weigh II is in Auto Mode (Auto LED
illuminated), press the Auto/Man Key to
put the system in Manual Mode. The Auto
LED turns off.
2. Use the Up Arrow or Down Arrow Keys to
scroll to the desired channel .
3. Press the Menu Key to display the Main
Menu. The display shows:
4. Press the F2 Key to access the I/O Menu.
The display shows:
5. Press the F1 Key to access the Setpt
Menu. The display shows:
6. Press the Menu Key to display the second
page of the menu. The display shows:
7. Press the F3 Key to add a setpoint. The
Weigh II displays the next available
setpoint, slot, and channel #. The display
looks like this:
Press any key (other than Esc, Auto/Man,
and Enter) to cycle through the unas-
signed setpoint channels until the one you
want is displayed. Press the Enter Key to
accept. The display flashes a message
acknowledging your selection and returns
to:
8. Add up to eight setpoints, and then press
the Menu Key to return to the first page of
the Setpoints Menu. The display shows:
9. Press the F1 Key to select Set and set up
a setpoint. The display looks similar to this
(depending on the number of setpoints you
added to the channel):
10. Press the F1, F2, or F3 Key to
select the desired setpoint. The display
shows:
ADD SETPOINT/SP1
Slot XX Chan# YY
F1 F2 F3
SETPOINTS
Delete Add
F1 F2 F3
SETPOINTS
Set Report
F1 F2 F3
WII MAIN MENU
Disp I/O Cal
F1 F2 F3
INPUT/OUTPUT MENU
Setpt Iout Serl
F1 F2 F3
SETPOINTS
Set Report
F1 F2 F3
SETPOINTS
Delete Add
F1 F2 F3
SELECT SETPOINT
SP1 SP2 SP3
F1 F2 F3
SELECT FUNCTION
Val Dead Hi/Lo
F1 F2 F3