KEYENCE GT Series - Manual (Page 2)

2
 Initializing the sensor
1. Press the SET button 5 times while pressing the MODE button.
2. “rSt.no” would appear, press the up/down arrow button and select
“rSt.YES”.
3. Press the MODE button. The sensor would be initialized.
 Changing the bank (program)
1. Press the up/down arrow button while pressing the MODE button.
2. The bank (program) would be switched to another one. Each bank
(program) will have an own HIGH/LOW/PRESET setting value.
Function setting mode
 How to enter the Function setting mode
1. Press the MODE button for at least 2 seconds.
2. Press the left/right arrow button and select the function number.
 01 Detection mode
Set the detection mode from [Standard], [NG hold], [Peal hold], [Bottom
hold] or [Peak to peak] mode.
 02 Response time
Set the response speed.
 03 Timing type
Set the timing time from [External input], [Rising edge] or [Falling edge].
Only available when
is set to [Standard], [Peal hold] or
[Bottom hold].
 04 Self timing level
Set the self timing level. Only available when is set to [Rising
edge] or [Falling edge].
 05 Self timing delay type
Set how the value is decided after the self timing is input, from [Static
hold] or [Delay timer].
Only available when
is set to [Standard], and is set
to [Rising edge] or [Falling edge].
 06 User specified delay time
Set the delay time used for .
Only available when is set to [Delay timer].
 07 Static hold delay stability criterion
Set how the decide the range, which is used to judge if the value is
stable or not, from [Default] or [User].
Only available when
is set to [Static hold].
[MODE] button
Main screen (P.V. value display)
While holding
down [MODE],
press the [Up].
While holding down
[MODE], press [Up].
While holding down
[MODE], press [Up].
While holding down
[MODE], press [Up].
The bank indicator is
turned off.
The bank indicator 1
is lit in green.
The bank indicator 2
is lit in green.
The bank indicator 3
is lit in green.