KEYENCE IL Series - Manual (Page 3)

3
 04 Alarm setting
Set the Alarm setting from [Default], [Clamp] or [User setting].
[Default]: When the measurement fails (out of the measurement range)
for 6(sampling rate set to 0.33ms) or 7(sampling rate set to except
0.33ms) times, the previous value is held until the next measurement is
successful.
[Clamp]: When the measurement fails (out of the measurement range),
the previous value is held until the next measurement is successful.
[User setting]: When the measurement fails (out of the measurement
range) for a certain number of times, the previous value is held until the
next measurement is successful.
 05 Output state
Set the output status from [Normally Open] or [Normally Closed].
Advanced setting mode
 How to enter the Advanced setting mode
1. Press the [MODE] button for at least 2 seconds.
2. Press the [MODE] or left/right arrow
button until the sub display will show
“End”.
3. Press the up/down arrow button. The
main display will show “Pro”.
4. Press the [MODE] or left/right arrow button and select the function
number.
Function Explanation
06 Hold function Set how to hold the value from
[Sample], [Peak], [Bottom], [Peak to
peak], [Auto peak] and [Bottom
peak].
07 Timing input Set how the timing input for the hold
function is used from [Level] and
[Edge].
08 Delay timer Set the delay timer for the judgment
output from [Off], [ON-delay],
[OFF-delay] and [1-shot].
09 Hysteresis Set the hysteresis for the judgment
value.
10 Analog output scaling Set how the analog voltage or
current should output, related to the
value.
11 External input Assign each input function to the 4
external inputs.
12 Bank switching method Set the way how to switch banks
from [Button] or [External input]
13 Memorizing the zero shift Set if the shift target value has to be
memorized to the EEPROM or not,
when the zero shift was input.
14 Interference prevention Set to use the interference
prevention function.
15 Number of digit Set the number of digits from
[Default], [0.001], [0.01], [0.1] and
[1].
16 Power saving Set to use the power saving
function.
17 Head display mode Set the lighting conditions for the
light on the sensor head.
18 Display color Set the color of the judgment light,
and the color of the main display.
LASER
BANK 0
1
2
3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
GO
HOLD CALC CHECK
LASER
BANK 0
1
2
3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
GO
HOLD CALC CHECK
1114-1
LASER
BANK 0
1
2
3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
GO
HOLD CALC CHECK
LASER
BANK 0
1
2
3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
GO
HOLD CALC CHECK