Holtgreven Ohaus Defender Series Bench Scales - Manual (Page 40)

EN-38 5000 Series Indicators
3.11.2 External Input
Set the function to be controlled by an optional external input device such as a foot switch.
OFF = disabled.
tArE = Tare function.
ZErO = Zero function.
PrINt
= Print function.
FUNCt = action specific to the current application mode.
S-S = the first external input changes the state of the relay. The second external input
(Start-Stop)
returns the relay to the original state.
t-S-S = the first external input initiates a Tare function, the second external input
(Tare-Start-Stop) changes the state of the relay. The third external input returns the relay to its
original state.
3.11.4 Input Beep
Set the beeper response to an external input.
OFF = Disabled.
ON
= Enabled.
3.11.4 Relay Output
Set the relay output parameters.
NOTE: If the Relay option is not installed the OUTPUT menu and associated menu items are not available.
Type
Set the initial state of the relay.
OPEN = the relay output is normally open.
CLOSEd = the relay output is normally closed.
CAUTION: The normally closed relay condition is only active while the Indicator is powered on.
When powered off or when power is removed, the relay condition returns to a normally open
condition. Restoring power to the Indicator will restore the closed condition of the relays.
Output Sequence
Set how the relay outputs react as the weight reading changes from under / accept / over.
NOrM = the previously enabled relay will be disabled as the next relay is enabled.
HOLd = the previously enabled relay will hold the same state as the next relay is enabled.