Holtgreven Ohaus Defender Series Bench Scales - Manual (Page 25)

EN-23 5000 Series Indicators
3.4.10 Beeper Volume
Set the beeper volume.
OFF = disabled.
LOW = soft
HI = loud.
3.4.11 Beeper Signal
Set how the beeper responds in the Checkweigh mode.
OFF = the beeper is disabled.
ACCEPt = the beeper will sound when the weight is within the Accept range.
UNdEr = the beeper will sound when the weight is below the Under setting.
OVEr = the beeper will sound when the weight is above the Over setting.
UNd.OVr = the beeper will sound when the weight is below the Under setting
or above the Over setting.
3.4.12 Button Beeper
Set how the beeper sounds when a button is pressed.
OFF
= no sound
ON = sound
3.4.13 End Setup
Advance to the next menu.
3.5 Readout Menu
Enter this menu to customize display functionality. Default settings are bold.
Reset No, Yes
Stable Range
0.5d, 1d, 2d, 5d
Filter Level Lo, Med, Hi
Auto Zero Tracking Off, 0.5d, 1d, 3d
Backlight Off, On, Auto (->Set 1,
Set 2, Set 5)
Auto Off Timer Off, Set 1, Set 2, Set 5
Gross Indicator
Off, Gross, Brutto
End Readout Exit READOUT menu