Holtgreven Ohaus Defender Series Bench Scales - Manual (Page 39)

EN-37 5000 Series Indicators
3.10.7 Alternate Command Sub-menu
Enter this sub-menu to set a different command character for the P (Print), T (Tare) and Z (Zero)
commands.
Alternate Zero
Set the alternate command character for Zero.
A to Z.
3.10.8 End COM1 or End COM2
Advance to the next menu.
Alternate Print Command
Set the alternate command character for Print.
A to Z.
Alternate Tare
Set the alternate command character for Tare.
A to Z.
3.11 I-O Menu
Enter this menu to set the optional input and output device parameters.
Default settings are bold.
Reset No, Yes
External Input Off, Tare, Zero, Print, Function,
Start-Stop, Tare-Start-Stop
Input Beep
Off, On
Relay Output Type (-> Open, Closed),
Sequence (-> Normal, Hold),
Contact (-> Simultaneous, Break-
Before-Make, Make-Before-Break)
When Stable (-> Off, On)
End.I-O Exit I-O menu
3.11.1 Reset
Set the I-O menu to factory defaults
NO = not reset.
YES
= reset.