Hardy HI 1769-FC - Manual (Page 39)

34
●
●
●
●
●
Chapter 4
Parameter
#hex
/Sub#
Default
Brief Description (Note: Expanded description are
listed below)
100% rate
6032 None
This is the MAX RATE that the system can
achieve. Maximum rate is calculated from the rate
calibration data.
7 Rate Cal
Percentages
xx33
7 rate calibration percents.
Uses 2 decimal places. 0.00-100.00
0 Percent
0033 0.00
MIN percentage value required to start the feeder,
calculated from the other calibrated points.
1st Percent
1033 20.00
A 5 point auto-rate calibration ends at this value.
This is not used in a 2 point calibration
2nd Percent
2033 30.00
Fourth value to be run in a 5 point calibration or
the second value to be run in a 2 point calibration.
3rd Percent
3033 40.00
Third value to be run in a 5 point calibration. This
is not used in a 2 point calibration
4th Percent
4033 60.00
Second value to be run in a 5 point calibration or
the first point in a 2 point calibration
5th Percent
5033 80.00
A 5 point auto-rate calibration start at this
programmed value
100 Percent 6033 100.00 MAX percentage value = 100%
End Rate Calibration Section
ADC Average 34 None 0x0034 // Read Only
STATE 35 None
0x0035 // Read Only
Mode Value
IDLE_MODE 0
AUTO_MODE 1
MANUAL_MODE 2
START_MODE 3
STOP_MODE 4
SHUT_OFFMODE 5
PAUSE_MODE
6
RATE_CAL_MODE 7
REFILL_MODE 8
FULL_MODE
9
MANUAL_HOLD_MODE 10
RATECAL_HOLD_MODE 11
INITIAL_REFILL_MODE
12
MANUALOP
37 None
Two decimal places. This it the output percent
when in MANUAL mode.
FAST_ROC
38 None
Lightly averaged rate of change, read only, RATE
decimal places.
zerocount 0x0A00 None AD counts at zero weight
calLowCount 0x0A01 None
Numbers or letters in the titles below correspond to the values in Column 2, Hex#, above
Parameter 2 Metric (Unit of Measure)
The Unit parameter sets the scale and related displays to one of the following options: