Hangar 9 3.1m Sukhoi SU-26MM ARF (3 Boxes) - Manual (Page 30)

30 Hangar 9 3.1m Sukhoi SU-26MM ARF Assembly Manual
 5. Glue the tray on the balsa stick using either Medium
CA or 5-minute epoxy. Hold pressure on the tray until glue
dries or epoxy sets.
 6. Strap the receiver using hook and loop.
Receiver battery Installation
Required Parts
Fuselage
Required Parts (not included)
(2) Spektrum 4000 2-cell LiPo
(2) 12-inch EC3™ extensions
Required Tools and Adhesives
Medium CA Masking tape
Hook and loop Hook and loop straps
 1. Apply masking tape to the bottom of the batteries.
Glue hook and loop using CA to the masking tape. Applying
CA in addition to the adhesive already on the hook and loop
ensures glue does not come undone on hot days.
 2. Glue using CA opposite side of hook and loop to the
sides of the fuselage as shown below.
 3. Overlap 2 inches of hook and loop straps provided in
the kit and secure the batteries by passing the strips through
the top and bottom slots.
The picture below shows the right battery setup.
The picture below shows the left battery setup.