Hangar 9 3.1m Sukhoi SU-26MM ARF (3 Boxes) - Manual (Page 29)

29 Hangar 9 3.1m Sukhoi SU-26MM ARF Assembly Manual
 11. Mount the regulator.
 12. Use the excess strap from the ignition module and
pull it over the ignition.
Note: Connect battery to switch, output of the switch
to regulator (6-inch extension is needed) and regulator
output to ignition. With this method, battery can be
charged directly through the switch charge port.
Receiver Mount and Throttle Servo
Regulator Installation
Required Parts
Receiver tray and stands Fuselage
Required Parts (not included)
JR 5203 regulator Receiver
Required Tools and Adhesives
Masking tape CA thin and medium
CA accelerator 5-minute epoxy
Dubro 1/4-inch foam Hook and loop
Hook and loop
 1. Prepare the receiver to mount on the tray, similar to
the ignition battery preparation in the previous section. Put
two rounds of masking tape at the bottom of the receiver.
Using CA glue 1/4-inch DuBro foam to the masking tape and
glue a piece of hook and loop to the foam.
 2. Glue opposite side of the hook and loop to the tray and
mount the receiver.
 3. Throttle servo regulator is mounted next to the receiver
using two pieces of hook and loop similar to step 1.
 4. Glue balsa sticks using thin CA to the floor of the
fuselage.