Doepfer DIY Synth do-it-yourself analog synthesizer - Manual (Page 3)

User's Guide page 3 DIY Synth Kit
Warranty
• All connections have to be carried out in the off-state of the DIY Synth kit (i.e. without
power supply)
• The DIY Synth kit is an electrostatic sensitive device. Avoid any electrostatic charges !
• Do not solder directly to any of the pin headers but use connectors to make the
connections between the DIY Synth kit and your application.
• Use only a power supply that corresponds to the specifications given in this manual (i.e.
+12V/GND/-12V).
• Applying a negative voltage less than –12V or a positive voltage beyond +12V at any of
the inputs may destroy the circuit.
• Avoid short cuts while DIY Synth kit is powered (e.g. caused by metallic or conducting
supports) !
• Ignoring any of these items will cause warranty loss !
• Return of the DIY Synth kit within the 2 weeks return time limit (valid only in Germany) is
only possible if all these items have been met. DIY Synth kit that have been soldered or
modified by the customer cannot be taken back.
Electronic knowledge is required to install and operate the DIY Synth kit. If you are not
sure whether your knowledge is sufficient please consult an expert. We cannot take
back kits that became defective because of wrong installation or wrong connection of
the controls or voltages. We also cannot take back modules or cables which have
been soldered by the user.