Cub Cadet 310-3000 - Manual (Page 30)

26 310-3000 IHT
13. Again using the assembly tool to compress
pistons (22), slide thrust bearing (25), be hind
the tool, into its cavity in front of the cyl in der
block (21) and as sem bled pistons.
NOTE: The thick race of thrust bearing
(25) must face the pis tons.
14. While holding the cylinder block assembly
(21) and the thrust bearing (25) in place,
with draw the assembly tool from between
the thrust bearing and the pistons.
15. Install motor thrust bearing retainer (57)
16. Reassemble the planetary differential as-
sem bly and in stall removed components
as di rect ed in their respective assembly
pro ce dures.
Figure 16. Motor Cylinder Block Assembly Tool
NOTE: To hold bypass plate (38) in po-
si tion, apply a small drop of grease to its
slot before installing.
8. Install spacer (27), 16T pinion gear (28),
wash er (82), snap ring (83), and washer
(82) onto motor shaft (24).
9. Insert the motor shaft assembly far enough
to seat the motor cylinder block (21).
10. Install piston washers (18), springs (17), and
pistons (16) in cylinder block (21).
11. If not already available, make an assembly
tool from 28 ga. sheet metal as shown in
Fig ure 16. The assembly tool must be free
of burrs and rough edges.
12. Using the assembly tool to compress pis tons
(22), install cylinder block assembly (21).
Be careful not to dislodge bypass plate
(38) when installing the cylinder block as-
sem bly.
Break sharp edges, both sides
2.250 inch
6.000 inch
1.125 Radius
Use 28 gauge
sheet metal