Cub Cadet 310-3000 - Manual (Page 20)

16 310-3000 IHT
2. Inspect trunnion arm lip seal (33), and re-
place if nec es sary.
ASSEMBLY
CONTROL ARM ASSEMBLY
1. Install trunnion arm lip seal (33), into main
housing (1).
2. Install stud (36), per Table 5, Page 16 and
fric tion puck (37).
3. Install control arm (26), onto trunnion arm
(31), and stud (36), with washer (77) and
nut (95) per Table 5, Page 13.
NOTE: If bearing (89) must be replaced,
install bear ing (89), washer (90), and
coun ter sink screw (92).
4. Install friction puck (37), washer (77), spring
(93), spac er (94), washer (77), and lock nut
(95). Tighten locknut to 120 in. lbs. (14 Nm),
then back off (1) full turn.
NEUTRAL ASSEMBLY
1. Install washer (87), return arm (34), actuat-
ing arm (35), and neutral spring (46).
2. Install adjusting puck (48), and bolt (88).
3. Reference Pages 9, 10 for proper neutral
adjustment procedures.
CONTROL ARM ASSEMBLY
Refer to Figure 9, Page 18
DISASSEMBLY
NEUTRAL ASSEMBLY
NOTE: The brake pull rod (152), washer
(77), and cotter pin (129) must be re-
moved before disassembling the Neu tral
Assembly (refer to Brake Assembly).
1. Remove bolt (88) and adjusting puck (48).
2. Remove neutral spring (46), actuating arm
(35), return arm (34), and washer (87).
CONTROL ARM ASSEMBLY
1. Remove upper lock nut (95), washer (77),
spring (93), spacer (94), washer (77), and
fric tion puck (37).
2. Remove lower lock nut (95), and trunnion
spac er (106), from the trunnion arm (31).
3. Remove control arm (26).
4. Remove friction puck (37), and stud (36), if
necessary.
INSPECTION
1. Inspect bearing (89), and replace if nec-
es sary. Remove bear ing by removing
coun ter sink screw (92), and washer (90).