Cub Cadet 310-3000 User Manual

Page 28

310-3000 IHT

REF. Part Name
70 Washer
71 Washer
63 51t Ring Gear
64 Planetary Carrier
65 Differential Miter Gear
66 Differential Miter Gear
73 Hex Jam Nut
76 Axle Shaft
80 Torx Head Screws
96 Bearing Sleeve

REF. Part Name
1 Main Housing
2 R.H. Housing Assembly
58 Carrier Pin
59 Planetary Gears
60 67t Spur Gear
61 21t Sun Gear
62 Planetary Thrust Plate
63 51t Ring Gear
64 Planetary Carrier
65 Differential Miter Gear
66 Differential Miter Gear
67 Differential Shaft
68 Differential Thrust Plate

REF. Part Name
117 Housing Pin
118 Axle Hub Assembly
119 Hex Nut

Figure 15. Planetary Differential Assembly

11. Install the planetary thrust plate (62).

12. Install the 67T spur gear (60) onto the

21T sun gear (61).

13. Slide washer (71) onto axle shaft (76).

14. Install the two housing pins (117) into the
main housing.

15. Apply a bead of sealant to the R.H. hous-

ing (2).

16. Install R.H. housing (2) by sliding it down
the axle shaft (76), over motor shaft as-

sembly (24, Figure 15) and onto main

housing (1).

17. Secure housings by installing the eight

housing screws (80), per Table 5, Page 13.

18. After the transaxle has been installed in

the vehicle, install the axle hub assem-

blies (118), according to the instructions
in "Transaxle installation," Page 30.