Cub Cadet 310-3000 - Manual (Page 24)

20 310-3000 IHT
INPUT SHAFT ASSEMBLY
Refer to Figure 12.
DISASSEMBLY
1. Drain the oil from the transaxle.
2. Remove snap ring (7), input shaft lip seal
(5), and spacer (4).
3. Remove input shaft assembly (12), (8),
(6).
4. Remove washer (13) from cavity.
INSPECTION
1. Inspect bearing (8) for damage and, if
nec es sary replace bearing, remove wire
re tain ing ring (6) and bear ing (8) from in put
shaft (12).
ASSEMBLY
1. Carefully install washer (13) onto top of
spring in cav i ty.
2. Press bear ing (8) onto in put shaft (12) and
secure by in stall ing wire retaining ring (6).
3. Install input shaft assembly (12), spacer (4),
and lip seal (5) into input bearing bore of
main housing (1).
4. Secure input shaft assembly (12) by in-
stall ing retaining ring (7).
Figure 12. Input Shaft Assembly
REF. Part Name
1 Main Housing
4 Spacer
5 Lip Seal
6 Wire Retaining Ring
7 Snap Ring
8 Ball Bearing
12 Input Shaft
13 Block Thrust Washer