Cub Cadet 310-3000 - Manual (Page 25)

310-3000 IHT 21
CHARGE PUMP ASSEMBLY
Refer to Figure 13.
DISASSEMBLY
Note: Before disassembling, note the
ori en ta tion of the charge pump cover
(54). Scribe or mark the charge pump
cover (54) for correct orientation during
as sem bly.
1. Remove two screws (29) from the charge
pump cover (54), and remove charge pump
cover (54).
2. Remove o-ring (53) and gerotor assembly
(52).
INSPECTION
1. Inspect gerotor assembly (52), cavity of
charge pump cov er (54), plate on which
cov er is mounted for damage or ex ces sive
wear.
ASSEMBLY
1. Install gerotor assembly (52) onto input shaft
(12) (not shown).
2. Install new O-ring (53) into charge pump
cov er (54).
3. Install charge pump cover (54), making sure
it is prop er ly oriented.
4. Secure charge pump cover (54) by installing
two screws (29), per Table 5, Page 13.
Figure 13. Charge Pump Assembly
REF. Part Name
1 Main Housing
29 Screw
52 Gerotor Assembly
53 O-ring
54 Gerotor Cover