Cub Cadet Medium Frame 3 Stage - Manual (Page 86)

Medium Frame 2 & 3 Stage Snow Throwers
82
24. Insert the key into the Output Shaft.
25. Insert the Output Shaft into the housing from the left
side, passing it through the Worm Gear. See Figure
7.43.
26. Rotate the Output Shaft until the key lines up with
the slot in the Worm Gear.
27. Push the shaft into the housing until the key passes
into the Worm Gear.
28. Install the left bearing.
29. Install the left snap ring. See Figure 7.44.
30. Install new seals for all four bearings.
31. Holding the Gear Box level, fill it with 4 oz of Cub
Cadet Drive System Plus (737-3120). See Figure
7.45.
32. Install a new cover gasket.
33. Install the Gear Box Cover. Tighten the screws to a
torque of 90 - 120 in lbs (10 - 14 Nm).
34. Install the gear box by following the procedures
described in the Auger Assemblies section of this
chapter.
35. Test run the unit in a safe area before returning it to
service.
Figure 7.43
Figure 7.44
Snap Ring
Figure 7.45
Oil level