Cub Cadet Medium Frame 3 Stage - Manual (Page 55)

700 Series 2-Wheel Track-Drive System
51
Steering Trigger Cables
To remove/replace a steering trigger cable:
1. Disconnect the spark plug wire from spark plug and
ground it against the engine.
2. Drain the fuel tank into an approved container.
3. Tip the snow thrower forward so that it rests on its
auger housing opening.
4. Remove the E-ring that secures the steering trigger’s
Pivot Pin. See Figure 5.37.
5. Remove the Pivot Pin.
6. Unhook the trigger from the cable. See Figure 5.38.
7. Gently pry/pull the cable end out of the Trigger
Bracket.
NOTE: Do not pull on the cable jacket. It will separate from
the cable end, damaging the cable.
Figure 5.37
E-ring
Figure 5.38
Figure 5.39
Pull here
Do not pull here