Cub Cadet Medium Frame 3 Stage - Manual (Page 53)

700 Series 2-Wheel Track-Drive System
49
23. Grease the needle bearing and the planetary gear
posts on the carrier with Arctic Grease (737-0318-
CRTG). See Figure 5.33.
24. Install the planetary gears on the carrier.
NOTE: The grooves on the planetary gears are for grease.
They are not timing marks.
25. Slide the washer, from behind the ring gears, onto the
shaft.
26. Grease the splines and the part of the shaft where
the needle bearings ride with Arctic Grease (737-
0318-CRTG). See Figure 5.34.
27. Install a Ring Gear on the right side of the shaft.
NOTE: The right side of the shaft is the side with the snap
ring groove.
NOTE: The ring gears and planetary carrier are the same
part number for each side.
28. Install a carrier with the Planetary Gears.
29. Install shim washers.
30. Install the snap ring.
31. Slide a ring gear on to the left side of the shaft.
32. Install a carrier with the planetary gears.
33. Install shim washers.
34. Slide the drive sprocket on to the left side of the shaft.
35. Install the roll pin into drive sprocket. See Figure
5.35.
Figure 5.33
Figure 5.34
Splines
Figure 5.35
Drive sprocket