COP-USA CD59NV-IR35YK - Manual (Page 36)

35
SOFT ADDRESS SET
The use can set up the SOFT ADDRESS, SOFT PROTOCOL and
SOFT BAUD RATE under this menu here to activate the soft
address function. And then the defined dome address by dip
switch will be disabled.
1) Move the cursor to INPUT (under DOME ID) and press IRIS
OPEN to enter the mode of setting dome ID, Move the joystick
to position the cursor beside :0 1 2 3 4 5 6 7 8 9” and press
IRIS OPEN to enter. And move the joystick again to select
numbers of dome ID and press IRIS OPEN to confirm. The
number selected will be input on the upper line.
2) Move the cursor to INPUT (the bottom menu) and press IRIS
OPEN to enter the mode of setting soft address, Move the
joystick to position the cursor beside :0 1 2 3 4 5 6 7 8 9” and
press IRIS OPEN to enter. And move the joystick again to select
numbers of dome soft address and press IRIS OPEN to confirm.
The number selected will be input on the upper line.
3) Enable or disable the soft address function. Press IRIS CLOSE
to exit last step. Move the cursor to to
“SOFTADDRESS:ON/OFF”. Press iris open to enter. Move the
joystick up or down to select ON of OFF. Press IRIS OPEN to
confirm.
4) Press OK to save and confirm all the settings and press
CANCEL to exit all the settings.