COP-USA CD55NV-IR35YK - Manual (Page 22)

IR Speed Dome Operating Manual
21
•ALARM
The dome system has 2alarm inputs and 1 alarm
output. (optional function). When an alarm is received, an
input signal to the dome triggers the user defined action
(such as presets, patterns, etc.), and at meantime the
alarm output signals is activated.
ALARM NO.: Move the cursor to the ALARM NO. Press IRIS OPEN to
enter and move the joystick up and down to select the alarm input
no. (Channel 1 and Channel 2)
INPUT STATE: Set the alarm contact status. There are two input
states, OPEN and CLOSE.
ALARM MODE:
ACTION: Set the alarm action:
ALARM OUT: Set the auxiliary to activate:
RESET TIME: Set up time for the alarm output (such as an alarm
buzzed) when is triggered by the detector.
START /STOP TIME: Set up the time to start alarm and stop alarm
ONLY under the AUTO mode under ALARM MODE.
OFF Alarm function is deactivated.
ON Alarm function is activated.
AUTO AUTO Alarm function will be activated and deactivated
between START TIME and STOP TIME.
NONE (default) No action
PRESET Dome goes to preset. (Default as Preset 1)
SCAN Dome starts auto scan (Default as Auto Scan 1)
SEQ Dome runs auto cruise (Default as Auto Cruise 1)
PATTERN Dome runs pattern (Default as Pattern 1)
OFF Not alarm output will be activated.
OUT1 An alarm action will close AUX 1 output..
OUT2 An alarm action will activate AUX2 output.
MAIN MENU
LANGUAGE :ENGLISH
RESTART
FACTORY DEFAULTS
HELP
EXIT
DOME SETTINGS
RESTART
FACTORY DEFAULTS
BACK EXIT
ALARM SETTING
ALARM NO. :1
CONTACT :N/O
INPUTSTATE :OPEN
ALARM MODE :OFF
ACTION :NONE
ALARM OUT :OFF
RESET TIME :10 SEC
START TIME:00:00
STOP TIME:00:00
BACK EXIT