Checkline TT05 - Manual (Page 5)

Series TT05 Digital Torque Testers User’s Guide
4
4 HOME SCREEN AND CONTROLS
4.1 Home Screen
No. Name Description
1 Measurement
direction
indicator
– indicates clockwise direction
– indicates counter-clockwise direction
These indicators are used throughout the display and menu.
2 Peaks The maximum measured clockwise and counter-clockwise readings, or
maximum measured 1
st
and 2
nd
peaks, when 1
st
/ 2
nd
Peak Mode has been
selected (see 1
st
/ 2
nd
Peak section for details). These readings are reset by
pressing ZERO or by powering the tester off and on.
3 Primary reading The current displayed load reading. See Operating Modes section for
details.
4 Units The current measurement unit. Abbreviations are as follows:
ozFin – Ounce-inch
lbFin – Pound-inch
lbFft – Pound-foot
Ncm – Newton-centimeter
Nm – Newton-meter
5 Load bar Analog indicator to identify when an overload condition is imminent. The bar
increases either to the right or left from the midpoint of the graph. Increasing
to the right indicates clockwise load, increasing to the left indicates counter-
clockwise load. If set points are enabled, triangular markers are displayed for
visual convenience. This indicator reflects the actual load, which may not
correspond to the primary reading (depends on operating mode). The ZERO
key does not reset the load bar. See Operating Modes section for details.
6 Mode The current measurement mode. Abbreviations are as follows:
RT – Real Time
PCW – Peak Clockwise
PCCW – Peak Counter-clockwise
See Operating Modes section for details about each of these modes
7 Number of stored
data points The number of stored data points in memory, up to 1000. Displayed only if
Memory Storage is enabled for the DATA key.
1
2
4
5 6
8
9
10
3
7