Checkline TT05 - Manual (Page 21)

Series TT05 Digital Torque Testers User’s Guide
20
12.1 Calibration Password
Select Calibration from the sub-menu. The display will appear as follows:
To set the password, select Enabled, then Set Password. Use the UP and DOWN keys to increment and
decrement the value, from 0 to 9999. When the desired value has been selected, press ENTER, then
ESC to exit the sub-menu.
12.2 Menu Key Password
If enabled, a password must be provided every time the MENU key is selected. Select Menu Key from
the sub-menu. Follow the same procedure as described in the previous sub-section.
12.3 Locking Out Other Keys
Other keys may be locked out individually. Select any combination of keys (MODE, ZERO, DATA) by
pressing ENTER in the Passwords sub-menu. Pressing a locked key will prompt the message “KEY
PROTECTED” and then revert to the previous screen.
12.4 Password Prompts
If passwords have been enabled, the following will be displayed when pressing the MENU key or
accessing the Calibration section:
Use the UP and DOWN keys to select the correct password, then press ENTER to continue.
If the incorrect password has been entered, the display will appear as follows:
To re-enter the password, press ESC to exit to the home screen. Then, access the desired function and
enter the password again when prompted.
If the password has been misplaced, it can be reset. Press ENTER to generate a request code. The
request code must be supplied to Mark-10 or a distributor, who will then provide a corresponding
activation code. Enter the activation code to disable the password.
ENTER PASSWORD
(0000 – 9999)
5000
INCORRECT PASSWORD
Reset password
Request code:
XXXX
Press ENTER or ESC
CALIBRATION PASSWORD
*
Disabled
Enabled
Set Password
(0000 – 9999)
5000