Brookfield Bath, Model TC-602 User Manual
Page 3
2
!
This symbol marks chapters and sections of this instruction manual which are particularly relevant to safety. When
attached to the unit, this symbol draws attention to the relevant section of the instruction manual.
!
!
This symbol indicates that hazardous voltages may be present.
!
!
:$&;!&--!/+)'%,0'/(+)!#$%'&/+/+1!'(!)&9$'<=!)$'>,#=!&+;!(#$%&'/(+?!
5%(#$%!(#$%&'/(+!/)!'3$!,)$%)@!%$)#(+)/7/-/'
!
$0'/(+!!>!$+$%&-!+9(%6&'/(+!
?!
+#&0/+1!
Your circulator is shipped in a special carton. Retain the carton and all packing materials until the
unit is completely assembled and working properly. Set up and run the unit immediately to confirm
proper operation. Beyond one week, your unit may be warranty repaired, but not replaced. If the
unit is damaged or does not operate properly, contact the transportation company, file a damage
claim and contact the company where your unit was purchased.
Remove any loose packing material that may have fallen into the reservoir during shipping. Before
powering up, check that nothing remains around the heater or circulator pump.
The instructions in this manual pertain to circulating baths both refrigerated and cooling coil types.
Read the section pertaining to the special instructions for your model.
?!!
.(+'$+')!!
Circulator Bath
TC-102P
TC-202P
TC-502P
TC-602P
TC-900P
Operators Manual, warranty
card
110-242
RS-232 Communication Cable
RSS-E1
3
/
16
in., ¼ in., and
3
/
8
in. Nylon
Barbed Tubing Adapters
510-011
6 ft. of ¼ in. ID Latex Tubing
HT-Tubing
Adapter Fittings*
¼ in. NPT – M16, Male (qty 2)
Beaker Platform(s) for Bath
Reservoir
— 600 ml
— 1000ml
701-402
701-402 (qty 2)
701-403
701-402
701-402
Deck Lid(s)
— Solid
— w/Beaker Holes
510-209
510-211
510-210
510-290
510-293
510-246
510-484
Blue Hole Plugs
— 3
1
/
2
inch
— 4 ¼ inch
Note: Do Not Use Above 120°C
TBPS300-295
TBPS300-295
(qty 2)
TBPS300-296
TBPS300-295
IEC Power Cord
(qty 1)
Note: Work area "opening" is designed to measure samples directly in the bath. If additional viscometer height is
required (spindle/guard clearance), either a 4 inch rod extension (part number BLM-4E) used with type A lab stand
or an 18 inch rod replacement (part number VS-38) used with type S lab stand are available from Brookfield or an
authorized dealer.
* Included with 50Hz Models only.