Brookfield Bath, Model TC-602 - Manual (Page 2)

1
8&7-$!(9!.(+'$+')!
Section 1 - General Information
1.1 Unpacking
1.2 Contents
1.3 General Description
Section 2 - Circulator Pump Connections
and Setup
2.1 Circulator Pump
2.2 Pump Inlet and Outlet Connections
2.3 Closed Loop Circulation
2.4 Open Loop Circulation
2.5 Filling the Reservoir
2.6 Reservoir Purge
Section 3 - Programmable Controller
Information
3.1 Front and Rear Panels
3.2 Heater/Pump Assembly
3.3 Specifications
Section 4 - Operation
4.1
Circulator Location
4.2 Reservoir Liquid Level
4.3 External Temperature Probe
4.4 RS232 Interface
4.5 Power
4.6 Setting the Safety Set Point
4.7 Power On
4.8 Local Lockout
4.9 Setting the Bath Temperature Set Point
4.10 Menu Navigation
4.11 Setting Operational Parameters and
Functions
4.11.1 Setting and Starting the Timer
4.11.2 Entering/Modifying a Temperature
Program
4.11.3 Writing a Temperature Program
4.11.4 Running a Temperature Program
4.11.5 Setting Preferences
4.11.6 Setting High/Low Temperature
Limits and Alarms
4.11.7 Selecting the Pump Speed
4.11.8 Fluid type (specific heat)
4.11.9 Displaying the Bath Temperature
Trend
4.11.10 Selecting the Temperature Probe
(Internal or External)
4.11.11 Setting the Auto-Refrigeration
Temperature
4.11.12 Setting the Display Contrast and
Timeout
4.11.13 Setting the Baud Rate
4.12 Controller Messages
!
Section 5 - Maintenance and Calibration
5.1 Heater
5.2 Pump Motor
5.3 Cleaning
5.4 Maintaining Clear Bath Water
5.5 Condenser, Air Vents, and Reusable Filter
(Refrigerating/Heating Circulators Only)
5.6 Calibration
Section 6 - Troubleshooting
6.1 Unit Will Not Operate (no heat, cooling, or
pumping)
6.2 No Pumping
6.3 Slow or Insufficient Pumping
6.4 No Heating
6.5 Insufficient Heating
6.6 No Cooling or Insufficient Cooling
6.7 Triac Failure
6.8 External Probe Failure
6.9 Recalling the Power-Up Language
Selection Menu
Section 7 - Reservoir Fluids
Section 8 - Appendix
8.1 Using Bath Controller with Rheocalc
Software
8.2 Using Bath Controller with DV-III+ or DV-III
Ultra Rheometer in Standalone Mode
8.3 RS232 For use without Brookfield
Software (for customers using their own
software)
Section 9 - Service and Technical Support
9.1 Replacement Parts
Section 10 - After-sale Support
Section 11 - Warranty
Section 12 - EC Declaration of Conformity
Section 13 - WEEE Declaration
!