Brookfield Bath, Model TC-602 - Manual (Page 20)

19
4.11.4 Running a Temperature Program
The Programmable Controller can store up to 10 user-defined time/temperature programs, which
can later be run with just a few simple commands. See - Entering/Modifying a Temperature Program
above for more information.
Programs may be run using either a Time- or Temperature-based priority. This priority is selected
under Program in the Preferences menu (see Setting Preferences below).
When Time is used, the program begins running when the bath temperature reaches the
programmed set point for step one. It continues running until the total programmed length of time for
all steps has elapsed, regardless of whether the set point temperatures for steps two and above
have been achieved.
When Temperature is selected as the priority, the program begins running when the bath
temperature reaches the programmed set point for step one. Each subsequent step is run until the
programmed set point for that step is reached, regardless of how much time has elapsed.
Selecting a Program— To select a temperature program, rotate the Select/Set Knob until the Run
Program menu appears and then press the Select/Set Knob.
If the Program # field is highlighted as shown above, press the Select/Set Knob and then rotate the
Select/Set Knob until the number of the program you wish to run is displayed.
Press the Select/Set Knob a second time to accept the displayed program number. If the word
Start
is highlighted, rotate the Select/Set Knob one click counter-clockwise to highlight the program
number.
Running a Program — Once you have selected and accepted the program number, rotate the
Select/Set Knob until
Start is highlighted. Press the Select/Set Knob; the program will automatically
begin running. The word “Starting” will appear at the lower left of the Run Program menu and will
remain there until the bath temperature reaches the set point programmed for step one. It will then
be replaced by the word “Running.”
While a program is running, the Run Program and main operational displays will alternate on the
LCD. The Run Program display shows the current step number, the target set point for the next step,
time at the current step, loop number, program status, and total elapsed time. The main operational
display shows bath temperature, set point, and program status.
Pausing or Stopping a Program — A program that is running may be paused or stopped at any time.
To do so, press the Select/Set Knob until
Starting or Running is highlighted and then press the
Select/Set Knob again. Rotate the Select/Set Knob until the desired function (Pause / Stop) is
highlighted and then press the Select/Set Knob. If you do not wish to pause or stop the program,
select and enter Escape.
If the program has been paused, “Paused” will appear on the lower left of the display. If the program
has been stopped, “Start” will appear on the lower left of the display.
To resume running a program that has been paused, press the Select/Set Knob, select Resume,
and then press the Select/Set Knob a second time. The program will resume operation from the
point of disruption. Select Stop if you wish to stop the program or Escape if you want to keep the
program paused.