360 Systems DigiCart/II Plus - Manual (Page 58)

46 • Operating Instructions DigiCart/II Plus Owner's Manual
Renumber Disk
Allows you to number disks for identification purposes. Press and hold the STOP button to view a
disk's number and name (if labeled). Once a disk has been assigned a number, it will retain that
number until this function is used to change it.
1. Press the ENTER button. The display will prompt:
0000
RENUMBER DISK
A cursor will blink on the first number.
2. Use the SELECT control and Left and Right POSITION buttons to choose a new
number.
3. Press the ENTER button to confirm your selection.
Assign Preset
Lets you assign a cut or Linear Stack to a single "Hot Key" on a DigiCart/II Plus Remote Control or
to the letter keys of an alphanumeric keyboard. When assigned, the selection will play immediately
with a single keystroke.
Cuts assigned to PRESETS may be Dolby AC-2 or linear format. The maximum
number of linear cuts is 16.
PRESETS must be cuts on a hard disk drive. (Not ID 0.XXXX or 6.XXXX)
PRESETS are subject to the currently selected RESTART MODE. (i.e.,
IMMEDIATE or ON COMPLETION).
Contents of a directory may be mass assigned to PRESETS by entering the
UTILITY MENU'S ASSIGN PRESET from the directory level.
PRESET 1 = 1 on the RC-210/220 or A on the alphanumeric keyboard.
PRESET 2 = 2 on the RC-210/220 or B on the alphanumeric keyboard, etc.
The alphanumeric keyboard's Scroll Lock must be ON for it to ASSIGN or PLAY
PRESETS. Scroll Lock may be ON or OFF to CLEAR PRESETS.
It is not necessary to clear a PRESET before reassigning it.
A SSIGNING A S INGLE P RESET U SING T HE RC-205; O R RC-210/220 (M ETHOD 1):
1. Press the UTILITY MENU button and rotate the SELECT control until the display
will show:
ASSIGN PRESET
PRESS ENTER/CANCEL
2. Press the ENTER button. The display will show:
PRESET 0 A
UNASSIGNED