360 Systems DigiCart/II Plus - Manual (Page 56)

44 • Operating Instructions DigiCart/II Plus Owner's Manual
2. Press the UTILITY button and rotate the SELECT control until the display shows:
COPY ORIGINAL
PRESS ENTER/CANCEL
3. Press the ENTER button. The display will then prompt with the current directory
ID and name the top line:
X.X DIRECTORY NAME
SELECT DEST. DIR
4. Use the SELECT control and the Left and Right POSITION buttons to select the
destination Directory.
5. Press the ENTER button. The display prompts:
X.X DESTINATION NAME
REPLACE DUPL. INDEX?
6. If you answer NO, the cuts in the source directory will copy to the same Index
Number in the destination directory unless that Index is occupied. If an Index
Number is occupied, the cut will be copied to the next open Index Number.
If you answer YES, the cuts in the source directory will replace any cut in the
destination directory that has the same Index Number (the last three digits of the
I.D. Number).
7. Press either the ENTER or CANCEL button. The display prompts:
X.X DESTINATION NAME
REPLACE DUPL. NAME?
If you answer NO, all cuts in source directory will be copied to the destination
directory, leaving all cuts in the destination directory in place (Subject to your
choice for Replace Duplicate Index.)
If you answer YES, any cuts from the source directory that have names that
duplicate a cut name in the destination directory, will replace those in the
destination directory.
If you answer NO to both ID and name, DigiCart/II Plus will copy to the chosen
directory, starting with the lowest available ID number.
NOTE: Copying begins immediately when both questions are answered, starting
from the selected cut.
DigiCart/II Plus will copy all cuts from the original directory, to the destination directory. The
display will indicate the name of each cut and its position in the directory as it is copied. Copying
begins with the currently selected cut in the source directory.
The display will show:
COPYING
SOURCE ID SOURCE NAME