360 Systems DigiCart/E - Manual (Page 89)

D-Net File Transfer • • • • 79
During Error Occurrence
When an error occurs for a received file, the cause of the error is displayed briefly and the percent complete
display changes briefly to “SKIPPING FILE”
When the transfer is complete, the display will briefly show:
“TRANSFER INCOMPLETE, ERRORS OCCURRED”
Then the display will show:
“GOOD FILES: XX, BAD FILES: XX”
This indicates the number of files received without errors and the number of files discarded due to errors.
Errors in the receiver can be due to:
• A faulty D-NET connection.
• Excessive disk fragmentation causing space allocation time to exceed the time allowed.
• Hardware failure in the receiving unit.
• Errors caused by the transmitting unit will usually be shown on the display of the transmitting unit.
D-Net Messages
MESSAGE
LOCATION
MESSAGE MEANING
SOURCE COULD NOT OPEN FILE
FILE TO SEND COULD NOT BE
OPENED
SOURCE FILE IS EMPTY FILE TO SEND IS EMPTY
SOURCE NO FILES TO SEND DRIVE TO SEND IS EMPTY
SOURCE PART OF FILE MISSING FILE IS SHORTER THAN EXPECTED
EITHER DISK ERROR
ERROR READING / WRITING THE
FILE TO BE
SENT / RECEIVED
EITHER TOO MANY ERRORS
20 DISK OR FILE ERRORS
OCCURRED
EITHER CANCELED BY USER
USER ABORTED TRANSFER BY
PRESSING EXIT or STOP
RECEIVER TIMED OUT
DATA WAS NOT RECEIVED FOR 10
SECONDS
RECEIVER MAIL BOX FULL
INDEX 999 IN THE MAIL BOX IS IN
USE
RECEIVER OUT OF DISK SPACE
DRIVE DOES NOT HAVE ENOUGH
SPACE TO SAVE THE FILE
RECEIVER DATA OVERRUN
DRIVE CANNOT ALLOCATE SPACE
IN TIME DUE TO FRAGMENTATION
D-Net Implementation on Instant Replay
®
and Short/cut™
DigiCart/E can send and receive D-Net transfers with Instant Replay, and receive D-Net from Short/cut.
Please refer to your Instant Replay or Short/cut manuals for complete information on the implementation of
D-NET on these products.