360 Systems DigiCart/E - Manual (Page 70)

60 • • • • Audio Editing
Setting FADE IN to a Specific Value
This method allows setting the Fade In length to a known value. This is accomplished without playing the
audio.
Select a cut and press EDIT . Select FADE IN by using selection knob. Press ENTER . The current
Fade In duration will be indicated on the display.
Use the selection knob and navigation arrows to adjust the Fade In duration.
Press PLAY to audition the new Fade In. Repeat the previous steps as needed to adjust the FADE IN
duration.
Press ENTER to save the new Fade In duration, or EXIT to close the cut with no change.
Setting FADE IN using Auto-Set
The Auto-Set feature allows setting a new FADE IN end-point during audition. In Edit mode, use the PLAY
button to start playback and the STOP button to set the Fade In duration and stop playback.
Select a cut and press EDIT. Select Fade In by using the selection knob. Press PLAY and the cut will
begin playing from the Head point. You will not hear the fade at this time. Press STOP to set the new
FADE IN end-point location.
After pressing the STOP button, the display will show any previous Fade In end-point on
the top line and the newly selected Fade In end-point on the bottom line. You may use the
selection knob and navigation arrows to adjust the FADE IN end-point value.
Press PLAY to audition the new Fade In. DigiCart/E will begin playback of the cut from the Head
point and continue playing until the cut ends or STOP is pressed. Repeat the previous steps as needed
to adjust the Fade In end-point position.
Press ENTER to save the new Fade In end-point, or EXIT to close the cut with no change.
F ADE O UT
After you have recorded a cut, you can program a FADE OUT length. FADE OUT is linear and always
ends at the TAIL point of the cut, and cannot exceed total cut duration. DigiCart/E limits FADE OUT
length to the time between the end of a FADE IN (if used, otherwise the HEAD point), and the TAIL point
of a cut. The maximum FADE length is 40 seconds.
When adjusting FADE OUT duration, time is measured as the number of seconds from the start of the fade
to the TAIL point. A value of 00:00:00:00:00 equals no Fade Out.
Setting FADE OUT to a Specific Value
This method allows setting the FADE OUT length to a known value. This is accomplished without playing
the audio.
Select a cut and press EDIT . Select FADE OUT by using selection knob. Press ENTER . The current
Fade Out duration will be indicated on the display.
Use the selection knob and navigation arrows to adjust the Fade Out duration.
Press PLAY to audition the new Fade Out starting at the Pre-Roll distance before the Fade Out point.
Repeat the previous steps as needed to adjust the FADE OUT duration.
Press ENTER to save the new Fade Out duration, or EXIT to close the cut with no change.