360 Systems DigiCart/E - Manual (Page 71)

Audio Editing • • • • 61
Setting FADE OUT using Auto-Set
The Auto-Set feature allows setting a new FADE OUT end-point during audition. In Edit mode, use the
PLAY button to start playback and the STOP button to set the Fade Out duration and stop playback.
Select a cut and press EDIT. Select Fade Out by using the selection knob. Press PLAY and the cut
will begin playing from the Head point. You will not hear the fade at this time. Press STOP to set the
new FADE Out end-point location.
Fades are limited to 40 seconds in length. If STOP was pressed at a point in the file farther than 40
seconds from the Tail point, the FADE OUT value will be set to 40 seconds.
After pressing the STOP button, the display will show any previous Fade Out end-point on
the top line and the newly selected Fade Out end-point on the bottom line. You may use
the
selection knob and navigation arrows to adjust the FADE OUT end-point value.
Press PLAY to audition the new Fade Out. DigiCart/E will begin playback of the cut from the Pre-Roll
point and continue playing until the cut ends or STOP is pressed. Repeat the previous steps as needed
to adjust the Fade Out end-point position.
Press ENTER to save the new Fade Out end-point, or EXIT to close the cut with no change.
O UTPUT G AIN
Allows the adjustment of the Output Gain (level) of a cut after it has been recorded. Gain may be adjusted
over a range of +6 dB to -90 dB, referenced to the initially recorded level. Output Gain is the only Edit
Menu function that is not time based. Output Gain may be adjusted for decibels or tenths of a decibel.
Just as with all other Edit Menu functions, this function is non-destructive and the gain setting is stored as
part of a cut's header. DigiCart/E automatically play the file with the adjusted gain setting.
Select a cut and press EDIT . Select OUTPUT GAIN by using selection knob. Press ENTER or STOP .
The display will show the current gain setting for the cut, relative to the originally recorded level.
Use the navigation arrows to select the decade value for decibels (<1.0>) or tenths of decibels (<0.1>).
Use the selection knob to adjust the Output Gain.
Press the ENTER button to save changes or EXIT to abandon changes.
Output Gain is not applicable to cuts in the Digital Data format.