360 Systems MAXX-2420EX - Manual (Page 110)

Page 110 MAXX-2420-EX Owner’s Manual
Rebuilding the RAID Array
Figure 49 - Selecting a drive to rebuild
• Select Rebuild Unit. The dialog above will appear.
• Select the available drive by clicking the check box.
• Press OK. The RAID array will begin rebuilding with the new drive. This process may take
a long time, but the MAXX-2420-EX can still be used.
• When complete, OK will be shown in the status for all ports on the Maintenance menu.
Replacing Hard Drives
The server hard disk drives have been factory tested and configured in a RAID 5 array. Each drive
is numbered (0-3) and must be attached to the correctly numbered data cable. Drive bays are also
numbered.
Please read Opening the Front Panel on page 116 for instructions on accessing the hard drive bays.
Detailed information about how to replace hard drives is on page 118.