Womerning cassette, Improper disc storage, Handling precautions – Panasonic RX-ES50 User Manual
Page 30: Improper tape storage, To erase sound previously recorded on a tape
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Womerning Cassette
Only compact discs having this mark can be
used with this unit.
To remove a disc from its case
n COMPACT
Ég®
DIGITAL AUDIO
Selection of cassette tapes
Press the center holder and lift the disc holding by the edges.
To hold the disc
Hold the disc by the edges so the surface is not soiled with finger
prints.
Fingerprints, dirt and scratches can cause skipping and distortion.
(Correct)
To store a disc in its case
(Incorrect)
Label
Insert the disc with label facing upwards and press downward at the
center.
If the surface is soiled
Wipe gently with a soft, damp (water only) cloth.
0(^> X
(Correct)
(Incorrect)
If the disc is brought from a cold to a warm environment, mois
ture may form on the disc
Wipe this moisture off with a soft, dry, lint-free cloth before using the
disc.
Improper disc storage:
You can damage discs if you store them in the following places:
• Areas exposed to direct sunlight
• Humid or dusty areas
•Areas directly exposed to a heat outlet or heating appliance
Handling precautions;
• Do not write on the label side with a bail-point pen or other writing
utensils.
• Do not use record cleaning sprays, benzine, thinner, static electric
ity prevention liquids or any other solvent.
• Do not soil with fingerprints.
Cassette tapes of 100 minutes or longer;
These tapes are handy for their long playback and recording time but
be careful about repeatedly stopping and starting, rewinding and fast
forwarding these tapes in short intervals as they are thin, tend to
stretch and may become entangled in the deck mechanism.
Endless tapes:
Failure to operate these tapes correctly may cause the tape to wind
around the revolving parts.
For this unit, it is recommended to use the tape which is appropriate
to the auto reverse mechanism.
If the tape loosensy take up the slack
Tape slack may cause the tape to break.
To prevent erasure of recorded sounds
Remove the tabs with a screwdriver or a similar object.
To re-record on a protected cassette, cover the slot with adhesive
tape.
Adhesive tape
Detection hols
Do not cover the detection holes on high position tapes.
Improper tape storage:
You can damage tapes if you store them in the following places;
• In high temperature (35°C or higher) or high humidity (80% or
higher) areas
•in a strong magnetic field (near a speaker, on top of a TV, etc.)
This can erase a recording.
•Areas exposed to direct sunlight
To erase sound previously recorded on a tape:
Disconnect the microphone.
1. Load the tape.
2. Press ■.
3. Press #/#ll.
30