Panasonic RX-ES50 - Manual (Page 18)

Recording from CD
Easy CD Recording (AUTO)
All the tracks are recorded in their original sequence onto a single tape. (The reverse mode is set to
Only part of a track may be recorded at the end of the top side. This track will be re-recorded In Its entirety at the beginning of the reverse
side,
Preparation: Insert the CD.
CD REC
MODE
I autorne
Press »CLEAR.
Press CD REC MODE to dis­
play “AUTO”.
AUTO^I-REC-^OFF
(The display changes each time the but­
ton is pressed.)
When “C------” appears;
You cannot make easy CD recording.
Follow the steps on page 16.
Length of the tape
required to record ail tracks
ssn
Press A of the tape lid and
load the tape which is longer
than the length indicated In
step 2.
The direction is automatically set to re­
cord on the side facing up {^ display
lights).
REC/PAUSE Press »• II to start record­
ing.
The tape is automatically rewound, and
after recording no signal for 10 seconds,
recording starts from the first track.
(T) Tape now rewinding
i- \ ' /
-
P E t J -
^ I 'È** Siiaaiffl
@ 10-second blank now being recorded
^ ^ i / ^
- R R E - R E C -
(3) Recording starts
Ed n-n I
u-u I
•Only part of a track may be recorded at
the end of the top side. This track will be
re-recorded in its entirety at the begin­
ning of the reverse side.
To stop recording:
Press H.
CD play also stops at the same time.
Recording your favorite tracks
After completing step 1, program your favorite tracks (see steps 2 to
4 on page 10).
Easy CD recording can not be used in combination with the random
play (see page 9).
18