Panasonic SC-CH75 User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Problem
Probable cause(s)
Suggested remedy
Reference
page(s)
While listening to ta
pes
Sound is low, intermittent,
or poor quality, noisy,
scratchy, or unsteady.
Heads are dirty.
Clean the heads.
17
Dolby noise reductions is set in the wrong
position.
Set it to match the Dolby NR recording
mode.
37
The deck does not enter the
recording mode.
The erase-prevention tabs are removed
from the cassette.
Attach tape to cover the space left by
removal of the erase-prevention tabs.
While listening to compact discs
The disc is not positioned correctly in the
disc tray.
Load the disc on the tray correctly.
12
The disc is loaded upside down.
Reload the disc.
The disc is dirty.
Wipe the disc with a soft doth.
36
The disc is scratched.
Replace the disc with a new one.
The disc is badiy warped.
The disc is a nonstandard one.
Replace the disc with a different one.
There is condensation inside the CD
changer.
Switch the power ON, and then wait for
60 minutes before using the CD changer
section.
The display will not show
the correct indication. Disc
play does not start when
you press the play button.
While using the remote control
The system cannot be
operated with the remote
control.
The batteries are installed in the reverse
polarity.
Reinsert the batteries in the correct polarity.
5
The batteries are worn.
Replace the batteries with new batteries.
5
The servicer will require all components to service your system. Therefore, should service ever be necessary,
be sure to bring the entire system.
Before moving or shipping this system:
Prepare the system as described below to prevent damage to the mechanism.
1. Remove all CDs.
2. Press CD,
3. Hold down stop button (■) for 2 seconds and then without releasing it, hold down both it and DISC 5 for 2 more seconds. (This will turn
OFF the power and set the so-called “shipping mode”.)
4. Unplug the system.
Avoid strong vibrations or impact while moving the equipment. The shipping mode will turn OFF automatically when you turn the power ON
the next time.
39