Panasonic SC-CH75 - Manual (Page 10)

Memory presetting
• If broadcast frequencies are preset in the memory, you can easily
tune in any of these frequencies from the system or remote control
unit.
• Up to 12 stations can each be set in the FM, LW and MW {For the
Australia and New Zealand: AM) bands with the automatic or man­
ual memory presetting.
Automatic memory presetting
This example in the figure shows how to preset stations in the FM
band.
Press TUNER, BAND to select
“FM”, “MW” or “LW”.
I For Australia and New Zealandl
Note that for Australia and New
Zealand, there are two bands of “FM”,
“AM” instead of “FM”, “MW", “LW”.
The power will come on automatically,
even if the system is on standby.
Press TUNING MODE to select
“MANUAL”.
Each time you press the button,
“MANUAL" and “PRESET will appear al­
ternately.
JJJJ
JJJJ
JJJJ
JJJJ
.M o
^ H HE
Press V or A until the display
shows the^ frequency from
which you want to begin auto­
matic memory presetting.
Holding the button down will scroll the
frequency. Repeatedly tapping on it will
change the frequency one step with
every touch.
White scrolling, if the radio picks up a
station, it will automatically tune it in (auto
tuning).
II
Press and hold MEMORY/SET.
Release the button when the frequency
display begins to change.
The unit v/ill automatically memorize the
received broadcast frequencies in se­
quence.
The moment the frequency is mem­
orized
The station and channel will be displayed
for about 1 second.
When auto memorization is complete
The last station to be memorized will be
left on the display.
To confirm the preset stations:
1. Press TUNING MODE to select "PRESET,
2. Press V or A,
Preset channel
Station
Auto memory presetting does not work when radio waves from the
broadcasting station are too strong or too weak.
In such case, carry out presetting manually, (See below.)
Manual memory presetting
(After step 2)
1. Press V or A to select the desired frequency, and press
"MEMORY/SET’. (“PROGRAM" flashes.)
2. Press V or A to select the preset channel, and then press
“MEMORY/SET’ during “PROGRAM" flashes,
“PROGRAM" indicator goes off.
Memory retention
The contents of the memory will continue to be stored for approxi­
mately 2 weeks, even if the power supply cord is disconnected.