Listening to tapes – Panasonic SC-CH75 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Listening to tapes
■ ■ .
■
c*,
• You can use either deck 1 or deck 2 for tape playback.
•This page shows an example using deck 1.
1
2
DECK1/2
Press TAPE, DECK 1/2.
The power will come on automatically,
even if the system is on standby.
0ECK1
Press ^ OPEN on deck 1, and
then insert the tape.
Insert the tape with the exposed tape fac
ing down.
Close the holder.
Front side
Press DOLBY NR if the cas
sette you want to play was
recorded using Dolby noise re
duction mode.
If the tape was not recorded using Dolby
NR, press DOLBY NR again so that the
Dolby NR indicator will go off.
JJJJ
JJJJ
7 a
/ ДК
Л CBS i m >
Press REV MODE to select the
reverse mode.
Each time you press REV MODE, one of
the indicators will light up.
The deck plays one side only, and
then stops automatically.
The deck plays both sides, and
then stops automatically.
The deck plays both sides 8 times,
and then stops automatically.
When you load tapes into both
decks; series piayback will be se
lected. (See page 17.)
I I
Ъ
Press ◄ or ► to start play-
back.
►: The forward side (front side) will play.
◄ : The reverse side will play.
VOLUME _ Adjust the volume level as you
like.
To stop tape playback:
Press
To change the deck to be used:
Press TAPE, DECK 1/2 to select the deck you want to use when you
load cassettes into both decks.
DECK 1 or DECK 2 indicator will illuminate to show
which deck you can operate.
^JJJ
JJJJ
JJJJ
О
Playback is interrupted white playing back tapes, if you open the
other deck.
For your reference:
The tape will automatically stop when a different source mode is
selected during its operation.
About priority of the deck:
When you load cassettes in both decks, the DECK 1 or 2 indicator
will light to show which deck you loaded last.
The system automatically selects “DECK 2" when you turn on the
power or whenever you switch to another source and then back to
the tape deck.
Type of tape which can be piayed correctly:
The unit automatically identifies the type of tape.
NORMAL Р031Т10МЛ^РЕ I
0
HIGH POSITION/TYPE 11
0
METAL POSITION^YPE IV
О