Prepare for recording, Press □ rec, To switch the timer off – Panasonic SC-CH75 User Manual
Page 29: To check settings (only while power is on), To change settings (only while power is on), Rritbl, For your reference
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
□flEC
Select the desired source and
then prepare for recording.
When you record from the radio:
Press TUNER, BAND to select band and
tune in the desired station.
When you record from a unit con
nected to the “AUX” terminals:
Press AUX.
Prepare for recording.
1. Insert a tape into deck 2 with the for*
ward side facing you.
2. Select the appropriate Dolby noise-
reduction system.
3. Select the reverse mode.
Press □ REC.
The unit will be switched to the power
standby condition.
• Recording will start roughly 30 seconds
prior to the set time.
• Recording sound will be automatically
muted.
To switch the timer OFF
Press [E REC and check "0 REC” goes out.
The settings made with the preceding procedure will however be kept
in memory.
To check settings (only while power is ON)
Press CLOCK/TIMER 2 times and check "0 REC” is displayed.
Two seconds later, the display will change in the following order.
(D Recording start time
@ Recording overtime
@ Recording source
To change settings (only while power is ON)
(T) Press 0 REC and check “0 REC" goes out.
(D Reprogram from step 1.
Using the timer at the same time setting continu-
ousiy
(You can accomplish this even if your stereo is on standby.)
The settings made with the preceding procedure will however be kept
in memory.
Press 0 REC and check “0 REC” is displayed.
To enjoy the desired source after the timer setting
is completed
1. After finishing step 6, switch on the power, and start playing the
desired source.
When listening to a cassette tape, use deck 1.
Even if you change the music source, the timer recording will start
with the preset condition.
2. Press POWER to set the stereo on standby after enjoying play,
and confirm a tape is inserted in deck 2.
rriTBl
• If the power is on, the timer will not function.
•The ON time and OFF time cannot be the same setting.
• If you switch the power to the standby mode while the record timer
is functioning, the OFF time setting wili not be activated.
• Play timer cannot be used in combination with a record timer.
For your reference
• Set recording to start roughly two minutes ahead of time.
• External sources must be connected to the “AUX" terminal. How
ever, time settings apply only to this stereo. For more information,
see the instruction manual of the connected unit.
• As long as “0 REC” is displayed, the timer will work everyday at the
same time.
29