Recording frain radio broadcasts, Fif eaco-sil, Recording from radio broadcasts – Panasonic SC-CH75 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Recording frain radio broadcasts
6
Advance the leader tape a few revolutions.
1
2
DECK 2
Press ^ OPEN on deck 2, and
then insert the tape.
Close the holder.
When making a Dolby NR re
cording, press DOLBY NR so
that the Dolby NR indicator
lights.
Fif eaco-sil
Press REV MODE to select the
reverse mode.
T — O n e side will record, and then the
tape will stop automatically at the
tape end.
Zly. Both sides will record (forward
side—»-reverse side), and then the
tape will stop automatically at the
tape end.
cZy>‘- Same as above. (When you press
REC START/STOP, “cr::)’’ will be
automatically switched over to
DECK1/2
Press TAPE, DECK 1/2 to se-
lect “DECK 2”.
I
I
I ^
J
^ 1 1 WMCV J
Press or immediately fol
lowed by
■.
b
This selects which direction the tape runs
in. ^
'4'
► :
Recording from forward side
Recording onto reverse side
Press TUNER, BAND to select
“FM”, "MW” or “LW”.
fpor Australia and New Zealand |
Note that for Australia and New
Zealand, there are two bands of “FM”,
“AM” instead of “FM”, “MW”, “LW".
Press TUNING MODE to select
"PRESET".
You can also select the desired broad*
cast station by tuning manually.
(See page 11.)
8
Press V or A to select the pre-
set chsnnel.
STOP
STAHT/STOP
Press REC START/STOP to
start recording.
JJJJ
JJJJ
ranm iSinetw
C M
Q Q
I ■ ;
r I I o U. I u .
To stop recording
Press REC START/STOP again.
Recording can also be stopped by pressing ■.
To cut an unnecessary part while recording
1. Press REC STAHT/STOP when hearing a unnecessary part.
The cassette deck will go into the stop mode.
2. Press REC START/STOP when wanting resume recording again.
Recording will continue in the same direction as before.
To reduce the noise while LW/MW
recording (Beatproof function)
While in the recording mode of LW/MW (For Australia and New
Zealand: AM) band;
Press FM MODE/BP while re
cording.
Each time you press the button, BP 1, BP 2 and BP 3 will be dis
played alternately. (For Australia and New Zealand: BP 1 and BP 2
will be displayed alternately and “AM" display appears instead of
“MW".)
Select the position where there is less noise.
Your attention is drawn to the fact that recording pre-recorded
tapes or discs or other published or broadcast material may
infringe copyright laws.