Panasonic DT2750MS - Manual (Page 9)

(D Main power switch
The main power switch is located on the lower right-side of the front bezel.
To turn on the monitor, push the main power switch so that the power indicator is lit green.
To turn off the monitor, push the main power switch again so that the power indicator is off.
By'pressing the POWER key on the remote control unit, the monitor is turned off and the power indicator is lit red,
however the monitor is not turned off completely. It is in stand-by mode, receptive to turn-on commands that may
be sent via remote control.
(3) Power indicator
The power indicator shows the monitor status (such as ON/OFF) normally.
Also, it indicates the power management status based on VESA DPMS as follows:—
H. Sync V. Sync Power indicator
Active Yes Yes Green
Stand-by No Yes Flashing (Interval 1 sec.)
Suspend Yes No 1 Flashing (Interval 1 sec.)
Active off No No Flashing (Interval 3 sec.)
r
@ Front control panel
This control panel can be used to make adjustments and input selections.
DTV/SET button
This button is used to
select DTV (Component
Video) input signal or to
set the control function or
the control level.*
DTV
-O
I SET
RGB1 / — button
This button is used to select RGB1 input signal or to decrease
the control function or the control level.*
RGB2 / + button
This button is used to select RGB2 input signal or to
increase the control function or the control level.*
L
RGB1 RGB2 AVI AV2
^ ,rO O
* These buttons have a dual
function;—
SET, -,
+ function works when
the menu is visible on screen.
MENU
____ I
AV2 button
This button is used to
select AV2 input signal.
AV1 button
This button is used to select
AVI input signal.
'MENU button
Control menu such as
brightness is separated to 2
groups. One is the picture
quality group (mainly
contrast). The other is the
geometric control group.
This button is used to select
the control menu group.
8