Panasonic DT2750MS - Manual (Page 11)

(D External speaker jacks
These jacks are for external speakers having an
impedance of 8 ohms.
To use the external speakers, place the speaker
select switch to the right position (EXT).
0 Speaker select switch
This switch is used to select either the internal
speakers or the external speakers.
To select the internal speakers, place the switch to
the left position marked “INT’.
To select the external speakers, place the switch to
the right position marked “EXT’.
CD RS-232C connector
This connector is used to control the monitor either
with RS-232C communication or the simplified wired
remote control.
(D RGB1/Component video BNC input connectors
These connectors are used for either RGB1 input
signals such as R, G, B, H and V from the computer
or the component video such as Y, P b , and P r
from
the component video equipment like the digital TV
receiver and DVD player.
To use these connectors as RGB1 or component
video input, place the BNC»HD D-sub switch to the
upper position marked “BNC”.
® BNCoHD D-sub switch
This switch is used to select the input signal of
RGB1 mode from the BNC connectors or HD D-sub
connector.
To select the signal from the BNC terminals, place
this switch to the upper marked “BNC”.
To select the signal from the HD D-sub connector,
place this switch to the lower position marked
“HD D-sub”.
® 15 Pin HD D-sub connector for RGB1 input
This connector is used for RGB1 input signals from
the computers.
(9) 15 Pin HD D-sub connector for RGB1 output
This connector is used for RGB1 output signals from
the monitor.
Note: 15 Pin HD D-sub connector for RGB1 output
is connected to the HD D-sub connector for
RGB1 input directly.
When two 15 Pin HD D-sub cables are
connected at the same time, place 75
ohm<=>HI-Z selection switch to the right
marked “Hl-Z”.
® 75 ohmc^Hi-Z selection switch
This switch is used when more than 2 monitors are
connected at RGB1 input mode.
Normal position is to the left, marked “75 ohm”.
When you connect a second monitor using the
original cable, set this switch to “Hl-Z” and the
second monitor’s switch to the “75 ohm” position {to
the right marked “75 Q”).
Caution: When you connect only one monitor, do
not set this switch to the “Hl-Z” position.
Display image will be too bright.
0 Audio input jacks
These jacks are used for RGB1 audio inputs or
component video audio inputs.
® Audio output jacks
These jacks are used for RGB1 audio outputs or
component video audio outputs.
10