For output, Rear panel, Av in or out connectors – Panasonic DT2750MS User Manual
Page 18: Front panel, S-video equipment, Rca cable (not supplied), S-video cable (not supplied), Connections for s-video equipment
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connections for S-video equipment
1,
Turn off the power switches of the video equipment
and/or your monitor if they are now on.
2
.
Connect the S-video cables {these cables are not
supplied with the monitor) and audio RCA cables to
the video equipment and the monitor as shown in
the following figures.
3
.
If it has not been installed, first connect one end of
the power cable to the monitor and then the other
end to the AC outlet*.
4,
Turn on the power switches of the monitor and the
video equipment.
5.
Select “AV1 ” or “AV2” by pressing front button
AV1
or
AV2
or pressing the
AV1
or
AV2
key on the
remote control unit (see page 21).
For OUTPUT:------------------------------------------------
The signal which is selected by the
AVI
or
AV2
button/key and displayed on the screen can be
available on the output connectors.
6.
This completes the installation of your monitor.
Caution:
*lf the AC outlet is of the two prong type,
please consult with a licensed
electrician.
Rear panel
AV IN or OUT connectors
Front panel
s:
Push to open
fWFrn
^ © 6 O
»■ VICEO snoeo *,UD10 1 WG&2
fj
S-video equipment
t—t-----------
RCA cable
(not supplied)
£j
From AV output
S-video cable (not supplied)
17