Panasonic SC-CH150 - Manual (Page 8)

Cùhnedtions
Connecting the accessories
Use wood screws
from a hardware
store when attaching
the antenna to a wait,
etc.
ESS
The configuration of the AC
power supply cord and FM
indoor antenna differ
according to the area.
1
Connect the FM indoor antenna.
Find a position on a wall or other surface where there is minimal
noise during reception and tape the antenna at that position. If
the noise level is high, it is recommended that an outdoor
antenna be installed. (See page 9.)
=o
Connect the speaker cables.
1. Twist the center conductor. If its
strands have become unraveled, twist
them tight again.
2. Connect the cables to the speakers.
Connect each of the cables to the
speaker terminal lever with the same
color.
3. Connect the cables to the system. To
prevent malfunctioning, do not short-
circuit the conductors.
Connect the rear cover.
Poke the antenna cables through the hole in the left side of the
cover, and speaker cables through the hole in the bottom of the
cover.
1. Assemble the AM loop antenna.
FOR UNITED KINGDOM ONLY
BE SURE TO READ THE CAUTION FOR AC
MAINS LEAD ON PAGE 4 BEFORE PROCEED­
ING TO STEP 5.
8
2. Connect the antenna to the system.
3. Find a position such as the top of the system or the area
behind a shelf where there is minimal noise during reception
and place the antenna at that position.
5
Connect the AC power supply cord.
Connect this cable last of all through the hole in the right side of
the rear cover.