Panasonic SC-CH150 - Manual (Page 14)

Manual tuning (when stations have not been preset)
C
CZ3§€
0 o e 0
Example; Tuning in FM 88.10 MHz;
1
................................................
2
C
Press POWER.
When the easy operation buttons shows
same as at step 4, you can skip steps 2
and 3.
Press MENU.
Press TUNER.
Press BAND to select “FM”.
Each time this button is pressed “FM”
"MW” or “LW” is selected alternately.
When you select
“MANUAL”, the button
display change over
between “SET’ and
"BAND”.
Press MODE to select
“MANUAL”. (The button dls-
play—
Each time this button is pressed, the dis­
play changes as follows:
O
PRESET «—I
[MANUAL C
I I
MRNURL
14
BANo -4 Press ▼ or A to tune In the
station.
iT
K
Lights when the station has been tuned
in properly.
I
Fh BB. I cm
STEREO
Lights when the broadcast is in stereo.
Press VOLUME to set the
desired volume level.
-RBdB
Automatic tuning:
Keep ▼ or A depressed for about 1 seconds. The first station is
picked up and the tuning stops automatically.
•If the buttons are not released even when the display starts to
move, the tuning will not stop automatically even if stations are
picked up.
•Ambient interference may cause the tuning to stop without picking
up any stations.
To stop tuning at any time:
Press the button again.
Frequency steps:
The frequency changes in the following steps:
0. 05.MHz steps for FM
9 kHz or 10 kHz steps for MW
9 kHz steps for LW
MW allocation settings:
This unit comes equipped with an electronic digital tuner that divides
the broadcast band into many small steps. These steps match the
assignable broadcast frequencies and Intervals in between.
Each country allocates (assigns) broadcast bands according to their
particular needs.
By adjusting the allocation, you can enable this tuner to receive MW
broadcasts allocated in 10 kHz steps.
1. Perform steps 1-3.
2. Select "MW” in step 4.
3. Press and hold BAND for approximately 3 seconds.
To return to the original indication, repeat steps 1 to 3 above.