Panasonic SC-CH150 - Manual (Page 37)

■
Using the ^€0
1
jf SET ^MODE"^ Programming the play end
(OFF) time:
/^=T=\ r 4 \ © Press ▼ or A to select the
hours.
0FFE0:30
Press SET.
SET-^ iTMODE^ ( 3 ) Press
T
or
A
to select the
minutes. ■
X
< ■ >
OFFFIJDO-
^
\
QFF I
0 Press SET.
11
KPLAY/EiREc Pross 0 PLAY/E] REC.
/10 CL
Q rec
Lights.
Check that “E REC” has appeared on
the display.
12
Press POWER.
At the programmed time recording com­
mences automatically with the sound
muted. To hear the sound, press VOL­
UME.
To check what has been programmed:
(Only when “0 REC” is on)
1. press MENU.
2. Press TIMER.
3. Press MODE three times to display “0 REC”,
The start time, end time and radio band are displayed in se­
quence for about 3 seconds each.
To change what has been programmed:
Repeat the procedure starting with step 1.
When “□ REC” appears on the display, press 0 PLAY/0 REC to
go off “0 REC” on the display, and repeat the procedure starting
with step 1.
To use the record timer with the same timer
setting;
1. Select the band and desired preset channel, and set the volume
of the sound you will be awakened by.
2. Press 0 PLAY/0 REC and appear "0 REC” on the display.
3. Press POWER and set the system to the standby mode.
To enjoy music or a program after programming;
1, Start playing the music or listening to the program after step 11.
Even if the sound source is changed, whatever has been pro­
grammed will be restored at the unattended recording time.
2. After finishing with the music or program, press POWER and set
the system to the standby mode.
After listening to a tape, check that the recording tape has been
installed in the holder.
•The timer will not work if the power is kept on.
•When the power is switched to the standby condition during timer
recording, the recording end time programming will be ignored
even if the power is turned back on and recording resumed.
•The unattended recording timer and wake-up timer cannot be used
in combination.
For your reference:
The record timer will be automatically cancelled after it has activated
once.
oiPLAY/QREc To relcase:
Press 0 PLAY/0 REC once and turn off
”0 REC”.
Each time this button is pressed, the dis­
play will indicate the following;
0 PLAY->0 REC
1—0«
J
The timer does not operate but the pro­
grammed times will be stored in the
memory,
37