Panasonic WZ-AD96 - Manual (Page 9)

F e a t u r e s
High bit, high sampling interface
• Compatible to MTRs and HDR in Dual-Wire AES mode, and to T.c
electronics and other major processor units in Single-Wire Hi-Speed
mode.
• ADAT Interface, 24 bit/48 kH 2/8 channel or 24 bic96 kHz/4 channel,
easy interface with HDR and DAW
• TDIF Interface, 24 bit/96 kHz/4 channel, easy interface with 24 bit
TDRS to build a 4-track Hi-speed/Hi-Sampling recording system.
• Sync to external Wbrdclock ranging from 44.1
-
6
%
up to 96 + 6%.
• Reference level adjustable from among -14, -16, -18 and -20 dBFS by
DIP switch.
• Wordclock output can be set to follow either the sampling frequency
or AES output signal .
Low noise power supply and separate grounding system
• Discrete power circuit contributes to low impedance and low noise.
• Unchangeable idea of low impedance and separate layout is applied to
grounding.
• Thick PCB pattern for power and ground, and large capacitors in
each channel assure channel separation.
• Special made screws (patented) assure continuity of ground level,
beside the GND terminal provided on the rear panel.
Precise Meters
• 0.05 dB accuracy digital meters, 10 point (AD96) and 3 point of
Signal/Reference/Peak (AD96M), Zoom and Adjust mode provided to
AD96.
• Peak detection adjustable for either use of a peak meter or clip meter.
• Reference level selected by the DIP switch to meet the connected
device’s.
1 0